How to use Curactin

May 07, 2018 2 min read

How to use Curactin

Wash on!

About a Nickle-sized Portion of Curactin should be very gently dispersed—with cleansed hands—over entire moistened face while Avoiding Eyes. Be certain to cover entire hairline. Gently, work the power-packed Curactin clays over face and effected areas. This can then be thoroughly rinsed away. Rinse! Rinse! Rinse!  OR:

Let activate!

After dispersing over complexion, allow Curactin to partially dry on the skin, this creates an activation. Curactin is fully active about a minute after application; however, complete drying is not necessary for effectiveness - it will only enhance the effectiveness. Allow to dry 1-2 minutes, the time it takes to brush your teeth etc. Then, Rinse! Rinse! Rinse!

Rinse off!

Thorough rinsing of Curactin is essential as all the dead skin cells, bacteria, dirt and debris have been absorbed into the herbs and clays. Rinsing ALL of this material away from the skin is essential for a successful procedure. Clear skin begins with clean skin, but not stripped or irritated skin. Complete rinsing of your skin is one of the most important steps you can take. You can never rinse too much, so it's better to feel like you are over rinsing, rather than not rinsing enough. Rinse! Rinse! Rinse!

Using as a mask

Dispense a nickel-size portion onto back of hand, dip freshly-rinsed brush into product and paint Curactin over entire moistened face while Avoiding Eyes. Or simply wash a very fine layer, you should be able to see your skin tone underneath. Let Activate 20 minutes before rinse, rinse, rinsing. This can be 2-3 times weekly max.

As Night Spot Solution

Prior to bed or simply in the evening. Dab a little Curactin onto a Q-tip and gently cover pimples and whiteheads with Curactin Acne Matrix. In the AM gently wet the dried Curactin and very carefully rinse away. If you are also using On-the-Spot Res-Q, it would go on under the Curactin. In other words, apply On-the-Spot Res-Q first.

What to Expect When Using Curactin

Curactin will not foam. It contains no soaps, nor sulfates.

If applying correctly, Curactin should dry on the skin in about 2 minutes. If it is not, the skin is either too wet or the product is being applied too heavily.

Very Little Curactin is needed as it is Highly Concentrated.

(Whether washing on or masking, only a very fine layer should be applied for best results.)

Curactin will begin to effectively exfoliate the skin; consequently, small areas of dryness and flaking will be noticed especially around pimples and whiteheads. This is normal and to be expected until that pimple, whitehead or region is cleared.

Most individuals using Curactin should begin to see improvement in their skin within 3 to 7 days of use.

Watch this video for more details. 

This article was written by an independent and third-party author specialising in CBD, hemp and cannabis research. Any opinion, advice or recommendation expressed in the article does not reflect the opinion of Formula Swiss AG or any of our employees. We do not make any claims about any of our products and refer to our disclaimer for more information.

Leave a comment

Comments will be approved before showing up.

Also in Health & Lifestyle

Benefits of organic guarana and ways to use it
Benefits of organic guarana and ways to use it

June 14, 2019 2 min read

Read more
How to use hemp powder
How to use hemp powder

June 12, 2019 3 min read

Read more
9 practical ways to lose weight this summer
9 practical ways to lose weight this summer

June 06, 2019 4 min read

Read more

Join our our newsletter to get a free welcome gift